6
INSTALLATION
INSTALLATION
10
ASSEMBLY
− Remove the front insulation (1)
− Mark mounting points (F) on the wall and drill
− Insert blocks (not supplied)
F
1
F
Ø7mm
F
Ø7mm
Ø7mm
58mm
81,5mm
277mm
9
Use suitable wall-mounting bolts and blocks.
− Set solar station at the centre
− Fasten the solar station with the fixing bracket (4), the
screws (2) and the washers (3) not supplied.
4
2 3
2 3
2 3
2 3
2 3
The display features a protective film that must be removed after
equipment commissioning.
11
WATER CONNECTIONS
1
2
3
4
5
0
6
R
M
RB
SV
T
E
VE
MB
135mm
89mm
ø18mm
45mm
M
Solar circuit outlet (3/4" M). Inlet of heat transfer fluid
coming from solar collector.
R
Solar circuit return (3/4" M). Outlet of heat transfer fluid
towards solar collector.
MB
Storage system delivery (3/4" M). Outlet of heat transfer
fluid towards solar storage system.
RB
Storage system return (3/4" M). Inlet of heat transfer
fluid from solar storage system.
SV
Safety valve drain
VE
Expansion tank fitting
E
Solar expansion tank (not supplied)
T
Safety valve outlet pipe (not supplied)
− Connect delivery fittings (M) and return fittings (R), found
at the top of the solar station, to the solar plant
− Connect delivery fittings (MB) and return fittings (RB),
found at the bottom of the solar station, to the storage
system
− Connect the safety valve drain to a pipe (T) to avoid burns
from expelled fluid and to permit the heat transfer fluid
to be recovered
− Connect expansion tank (E), suitable for solar plant ap-
plications, to 1/2” fitting (VE).
9
Fasten expansion tank as explained in the instruction sheet
supplied with the accessory.
9
For hydraulic connections, use silicone seals having a hard-
ness of at least 80SH. If no seals can be used, seal fittings
with high-temperature sealant (>180°C) suitable for solar
applications.