Riello GI/EMME 1400, Руководство пользователя

Страница: 19 / 80

17 20162463 GB
Installation
5.6 Lifting points
Fig. 11 shows how to apply the burner to a boiler with a
headpiece that is not cooled.
The refractory wall must not extend beyond the end of the
combustion head of the burner.
Tab. I
5.7 Positioning the electrode
5.8 Air damper setting
The setting of the air damper is carried out by acting on the
variable profile cam. This operation must be performed after
regulating the pressure variator and the combustion head.
With burner on, disconnect the servomotor from the power supply
by disconnecting the fast-on pin on the electric control shelf, and
release the movement by pressing the release button that allows
the manual rotation of the cam.
Calibrate in sequence the maximum output, the minimum output
and the intermediate outputs.
At the end of the operation, check all calibrations, restore the
electrical connections of the servomotor and lock the adjustment
screws by means of the transversal ones.
Provide an adequate lifting system (Fig. 11).
Lift the burner by means of the hooks to fix it to the
boiler without separating it from the combustion
head.
mm MIN MAX
GI/EMME 1400 200 300
GI/EMME 2000 200 300
GI/EMME 3000 300 400
GI/EMME 4500 300 400
ATTENTION
Before fitting the burner on the boiler it is advised
to fit the nozzle as specified later.
Be careful as some drops of fuel may leak out
during this phase.
ATTENTION
The seal between burner and boiler must be
airtight.
Fig. 11
20167876
M A X - M I N
ATTENTION
Position the electrode according to the
dimensions shown in Fig. 12.
Fig. 12
D1390