TECHNICAL ASSISTANCE SERVICE
38
4
2
kWh
Esc
F1
F3
F4
F2
A1
3
SOLAR CONTROLLER
The first time you switch on the boiler, you will need to set
time and day. To do so, proceed as follows.
- Turn the function selector (3) to
" "
-
Turn the parameter selector (4) until the "Clock" menu
appears.
-
Press the confirm key (2).
-
Turn the parameter selector (4) to set the desired time.
- Press the confirm key (2) to confirm.
- Repeat the above steps to set the date.
-
Turn the function selector (3) to
"
"
b
You can exit programming mode at any time simply
by turning the function selector (3). If you exit pro-
gramming mode in this way, any changes made but
not confirmed (by pressing the confirm key) will be
lost.
STARTING UP THE BOILER
If a timer or room thermostat is installed, these must be
switched on and adjusted to a temperature higher than
current room temperature before the boiler can start up.
The boiler will remain in stand-by mode until the burner
ignites following a request for heat. The green LED (3) on
the left of the control panel lights to show that a flame is
being detected.
The boiler will carry on functioning until the set tempera-
tures are reached, when it will return to stand-by mode
while continuing to display the central heating flow tem-
perature.
If any ignition or functioning errors occur, the boiler per-
forms a “SAFETY SHUTDOWN”. The green LED on the
control panel goes out and an error code flashes on the
display. The red LED (5) indicates a burner lock-out. See
the “WARNING LEDS AND ERRORS” section for details
on the various error codes and how to reset the boiler.
0
bar
4
1
3
2
°C
0
120
20
100
40
80
60
3
0
bar
4
1
3
2
°C
0
120
20
100
40
80
60
5
Содержание 20044966
Страница 54: ...TECHNICAL ASSISTANCE SERVICE 54 ...
Страница 55: ......