Riello Burners BS2/M, Инструкции по установке, использованию и обслуживанию

Страница: 43 / 52

2861
9
GB
5.2 ELECTRICAL CONNECTION
(As set up by the installer)
D4548
Key to lay-out :
PS – Remote manual reset
MB
– Burner terminal block
X7 – 7 pin plug
X4 – 4 pin plug
X6 – 6 pin plug
h2 – 2nd stage hourcounter
TR – High-low mode control device system
h1 – 1st stage hourcounter
S – Remote lock-out signal
IN
– Manual burner stop switch
WITHOUT REGULATOR
(high-low progressive mode operation)
WITH REGULATOR
(fully modulating mode operation)
Key to lay-out:
PS
– Remote manual reset
MB – Burner terminal block
X4 –
4 pin plug
X7 –
7 pin plug
BT – Temperature probe
BP – Pressure probe
TL – Limit control device system
T6A – Fuse
TS
– Safety control device system
PG – Min. gas pressure svitch
VR – Adjustment valve
VS
– Safety valve
Do not connect any contact
between
T6 and T8 at the
4 pin plug and between T1
and T2 at the 7 pin plug, in
order to avoid interference
with the regulator.
ATTENTION
If the boiler has a the 7 pin plug, it should be replaced with the one supplied with the burner.
WARNING
D7137