20
6.3 Using the varithek
®
grill
6.3.1 varithek
®
Grill 1/1
1/1-gp-3400-sp
Before using please ensure every single time that the grease collection tray is in
place underneath the appliance.
During the initial inspection of the device in the factory, the grill surface can show
annealing colour. Please be aware that this does not impair functionality.
Push the device into the system module
Switch on device at main switch - green LED lights up
Set the desired power level at the power controller
Turn to the right - for more power and to the left - for less power
Work only with non-scratching tools.
When you are finished, switch off the device at the main switch.
ATTENTION!
Close the lower system module flap, otherwise the
device can slip out.
Leave the upper part of the system module flap open,
otherwise the device could overheat.
6.3.2 varithek
®
Grill 400
400-gp 4800 sp
Before using please ensure every single time that the grease collection tray is in
place underneath the appliance.
During the initial inspection of the device in the factory, the grill surface can show
annealing colour. Please be aware that this does not impair functionality.
Configure device for work surface
The heating zone is divided into 3 subzones (controlled individually by sensors). This
ensures that only the energy that is actually required is used. (turndown)
Switch on device at main switch - green pilot light lights up
Set the desired power level at the power controller
Turn to the right - for more power and to the left - for less power
Work only with non-scratching tools.
When you are finished, switch off the device at the main switch.
6.3.3 varithek
®
Grill 800
800-gp 9600 sp
(illustration)
Before using please ensure every single time that the grease collection tray is in
place underneath the appliance.
During the initial inspection of the device in the factory, the grill surface can show
annealing colour. Please be aware that this does not impair functionality.
Configure device for work surface
These appliances have 2 heating circuits, the left dial for the left half and the right
dial for the right half. The heating zone is divided into 3 subzones (controlled
individually by sensors). This ensures that only the energy that is actually required is
used. (turndown)
Switch on device at main switch - green LED lights up.
Set the desired power level at the power controller
Turn to the right - for more power and to the left - for less power
Work only with non-scratching tools.
When you are finished, switch off the device at the main switch.
