Operation (continued)
Battery Installation
Blowing Feature
Your wet/dry vac has the capability to blow
sawdust and other debris and to be used
as a blower for yard work, patio cleanup
and workshop applications.
NOTE: The blowing port is located
opposite the vacuum port.
WARNING: Always wear safety
eyewear complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before
using as a blower.
WARNING: To reduce the risk of
injury to bystanders, keep them clear
of blowing debris.
9
CAUTION: Wear a dust mask if
blowing creates dust which might be
inhaled.
WARNING: Turn unit OFF before
removing/installing the battery.
CAUTION: To reduce the risk of
hearing damage, wear ear protectors
when using the vac/blower for
extended hours or when using it in a
noisy area.
2. Lay the power head on a clean dry area
while emptying the drum or changing
the filter.
3. Dump the drum contents into the proper
waste disposal container.
NOTE: Lithium Ion or NiCad Battery
and Charger sold separately.
Installation of Battery
NOTE: For maximum performance, use
24V battery.
WD2450 will operate with the following
types of batteries: 24V Battery No.
130377001 & 18V Battery No. 130254003.
1. While holding the Wet/Dry Vac’s handle
with one hand, pull open the battery
compartment cover.
2. Slide the fully charged battery into the
battery receptacle until you hear an
audible click. Do not push the release
buttons on the battery at this time.
Removal of Battery
1. Press both release buttons, located on
each side of the battery, at the same
time and slide battery out of the battery
receptacle.
Lithium Ion or
NiCad Battery
Battery
Compartment
Cover
SLID
E
Release
Button (2)
SLIDE
Battery
Receptacle
SP6649_1.qxd 2/14/07 10:53 AM Page 9
