RIDGID WD1660, Руководство пользователя

Страница: 6 / 20

6
Filter Assembly
1. Carefully slide the filter over the filter
cage, lining up hole in filter with
threaded stud and sliding it over the
center ring covering the 3 slots until the
filter stops against the lid.
2. Place filter nut onto threaded screw and
tighten it down. Finger tighten only.
NOTE: Lever of filter nut should be away
from plate as shown.
IMPORTANT: Do not overtighten as this
may deform or crack the filter cage or the
filter.
Accessory Caddy Assembly
Locate the two 5-1/4" wheel assemblies
and the two dual wheel casters in the car-
ton. The casters are designed to fit in the
front of your new accessory caddy and
the larger wheels fit the rear of the caddy.
To Install the Wheels/Casters
1. Place the accessory caddy upside
down on a flat surface as illustrated.
2. Insert the dual wheel casters into the
bottom of the accessory caddy as
shown (2 places).
3. Push on the caster until the flange on
the caster stem is inserted all the way
into the socket. You will be able to hear
the flange snap into the socket. The
caster will swivel easily when position-
ing is correct.
4. Position the dove tail portion of one of
the wheel assemblies into the acces-
sory caddy as illustrated. Tap the wheel
support into the accessory caddy with a
soft mallet. Repeat for the second
wheel assembly.
5. Turn the accessory caddy upright.
This completes the assembly of your 16
gallon wet/dry vac accessory caddy.
The caddy is now ready for the sixteen
gallon drum of your RIDGID wet/dry vac.
Filter Nut
Filter
Filter Cage
Threaded
Screw
Dual Wheel
5-1/4" Wheel Assembly
Accessory Caddy
Caster