26
Assembly (continued)
Assembling Herc-U-Lift™ Caster
System
Assembly Tips
1. The caster set consists of an upper and
lower assembly.
2. First put the upper and lower assembly
together following instructions below.
3. Loosely assemble all nut and screw
connections. After mounting the assem-
blies on the table saw, adjust frames on
center, and then securely tighten all fas-
teners.
4. When assembling the frames, Tube
Rear (27" long) and Tube Front (13-7/8"
long) must be assembled so the large
hole faces down towards the floor. See
the illustration before assembling.
Upper Assembly
1. From bag of loose parts remove the fol-
lowing hardware:
*4 Hex Head Screw w/Washer, 1/4-20 x
1-1/2
*2 Hex Nuts w/Serrated Flange 7/16
*4 Lock Nuts 1/4-20
*Items marked with asterisk (*) are
shown actual size.
2. From the loose parts find the following:
1 Plate Assembly
2 Tube Rear (27" Length)
1 Channel Rear
2 Casters
3. Assemble Tube Rear (27 inch length) to
each side of the Plate Assembly as
shown using four each 1/4-20 x 1-1/2
hex head screw and lock nut. Loosely
assemble at this time.
NOTE: The larger hole at the end of the
tube, opposite the plate assembly,
must face down.
4. Align rear channel with holes in the rear
tubes as shown. Assemble caster
through channel and tube as shown.
Fasten with 7/16 nut as shown. Loosely
assemble at this time.
1/4-20 x 1-1/2
Hex Head Screw w/Washer
7/16 Hex Nut
1/4-20
Lock Nut
w/Serrated Washer
Plate Assembly
Caster
Channel Rear
Tube Rear
Tube Rear
Large Hole
Facing Down
Tube
Channel
Rear
Plate
Assembly
Rear
