999-999-207.10_REV. A
10
RP 342-XL Press Tool
Figure 10 – Installing Press Ring Onto Fitting
Figure 11 – Attaching Actuator to Press Ring
5. Release the run switch.
6. Squeeze actuator arms to open actuator. Remove
actuator from fitting.
7. Remove ring from fitting. Avoid sharp edges that may
have formed on fitting during pressing operation.
8. When operation is complete, depress ON/OFF button
one time to turn tool OFF. Remove battery from tool.
Inspecting The Pressed Connection
1. Inspect the pressed fitting for:
• Full insertion of tube into fitting.
• Excessive misalignment of the tubes. A slight
amount of misalignment at a pressed connection is
considered normal.
• Incorrect attachment alignment with the fitting con-
tour. Distorted or deformed fitting.
• Any other issues per the fitting manufacturer.
This could include the removal of a control ring or
decal (used to indicate the connection has not
yet been pressed).
If any issues are found, remove fitting and install a
new connection.
2. Test connection in accordance with fitting manufacturer
instructions, normal practice and applicable codes.
Storage
Remove battery from tool. Store press tool and battery in
case. Avoid storing in extreme heat or cold. The tool will not
turn ON if the tool is outside the specification range. This
will be indicated by the tool status lights.
(See Figure 5.)
Store tool in a dry, secured, locked area
that is out of reach of children and people unfamiliar with
the Press Tools. The tool is dangerous in the hands of
untrained users.
Maintenance Instructions
WARNING
Make sure battery is removed from tool before per-
forming maintenance or making any adjustment.
Cleaning And Lubrication
1. Wipe the tool clean daily with a clean dry cloth.
2. Inspect the attachment mounting pin and lubricate the
pin with silicone lubricant as needed.
3. Check return springs in attachments with each use.
Attachments should open and close freely with only
moderate finger effort required.
Required Maintenance By RIDGID
Authorized Independent Service Center
The RP 342-XL Press Tool must be serviced at set intervals
by a RIDGID Authorized Independent Service Center to
ensure proper operation. This will be indicated by a tool sta-
tus light
(See Figure 5)
.
Service And Repair
WARNING
Improper service or repair can make machine
unsafe to operate.
Service and repair on the RP 342-XL Press Tool must be
performed by a RIDGID Authorized Independent Press
Tool Service Center.
For information on your nearest RIDGID Authorized
Independent Service Center or any service or repair ques-
tions see
Contact Information
section in this manual.
WARNING
