RIDGID R4251, Руководство оператора

Страница: 21 / 36

21
MOUNTING SAW TO STABLE SURFACE
See Figure 23.
To ensure safe and accurate operation, this
saw should be mounted to a stable and level
surface such as a workbench. To mount the tool to a stable
surface, do the following:
1.
Locate the four mounting holes (F22) in the base of the
saw.
2.
Secure the tool to the mounting surface using 3/8 inch
diameter machine bolts, lock washers, and hex nuts
(not included). Make sure the bolts are long enough to
accommodate the saw base, lock washers, hex nuts,
and the thickness of the workbench.
3.
Tighten all four bolts securely.
4.
Check to make sure that the saw is secure before
operation.
Figure 23
Figure 24
MOUNTING AND TRANSPORTATION
INSTALLING WORKPIECE SUPPORT
EXTENSIONS
See Figure 24
To assemble the support extensions:
1.
Insert one of the support extensions (PC5) to the
underside of the base at the cast-in handle cut-outs (B).
2.
Make sure support extension (PC5) is flush with the
base and inserted into the rounded slots of the cut-
outs (B). The rivets (C) are used to prevent the support
extension (PC5) from sliding out of the base during use.
These rivets should be positioned on the inside of the
base.
3.
Place the extension clamp (PC6) onto the support
extension and the screw that is pre-attached to the
base.
4.
Once the extension clamp (PC6) is in place, put the
spring washer (PC7) first and screw the wing nut (PC8)
provided onto the screw.
5.
Tighten the wing nut (PC8) to fully secure the support
extension (PC5).
6.
Repeat on the other side.
PC6
PC7
PC5
C
PC8
F22
F22
B