RIDGID R4251, Руководство оператора

Страница: 16 / 36

16
ADJUSTMENTS
ALIGN THE BLADE TO FENCE
Your saw is calibrated at the factory to cut true. Over time the
saw’s calibration may drift and will need to be re-calibrated.
See Figure 12.
1.
Unplug the Saw.
2.
Lower the saw head all the way down to the transport
position and engage the saw head lock pin to hold it
in place. Push the saw head into the fully retracted
position and engage the slide lock lever to hold it in
place.
3.
Set the miter position to 0° and allow the miter detent
to lock into position.
4.
Set the bevel position to 0°. Engage the bevel lock
handle to lock bevel angle.
5.
Place a square (A) against the fence and the face of the
saw blade.
NOTE:
Make sure the square contacts the flat part of the
blade and not the teeth.
See Figure 13.
6.
If the blade face is not flush with the square you will
need to adjust the miter detent plate (B).
7.
Loosen the four screws (C) and move the miter table to
adjust the miter detent plate position. Set so the fence
and blade are flush against the combination square.
Make sure the miter lock knob is not locked, so the
miter detent plate may be adjusted.
8.
Re-tighten the four screws and re-check the blade-to-
fence alignment.
NOTE:
After squaring adjustment have been made, it may be
necessary to loosen the indicator screws (D) and reset them to
zero.
Figure 13
Figure 12
LOCK
UNLOCK
C
D
A
B