SWITCH WIRING
Wiring: Wire your lights according to the instructions included with the light.
Take care to avoid any heat sources and sharp or abrasive surfaces.
SWITCH WIRING (SINGLE AND SETS)
- P1- Black Wire
= Switch Ground
- P2 -
Blue
Wire/
Red
Wire w/ Heat Shrink
= Switch Output to Relay
- P3 -
Red
Wire
= Switch Input Power
Drill Holes to
5/16”
Drill Holes to
5/16”
1)
Cut out only the dotted areas, including the two outside holes.
2)
Ensure your flat surface allows for the depth of the light.
3)
Tape the template, or secure by other means, to your surface.
4)
Mark both drill holes and center area of template with marker.
5)
Remove your template and double check your markings by placing
rubber gasket over area.
6)
After complete check is done to ensure proper alignment, remove
marked surface material by using pneumatic tools.
7)
Remove or file down rough edges and excess trimmings to allow for
light to correctly be placed.
8)
Place gasket over light so it rests behind the face of the flush mounted
light. Insert light into opening.
9)
Insert your 2 bolts into light and through your surface, tighten nuts
onto bolts evenly to allow for a proper gasket seal.
10)
Wire light according to provided instructions.
SR-M MOUNTING TEMPLATE
Measurements are in Inches
WHEN PRINTING:
PRINT 100% ACTUAL SIZE
DO NOT SIZE TO FIT
NOTE:
GOLD
Spade is the Top of Switch, 3/4” mounting hole required
Black Wire
= Switch Ground
Blue
Wire/
Red
Wire w/ Heat Shrink
= Switch Output to Relay
Red
Wire
= Switch Input Power
1
2
3
