RIDGID OL40135SS, Руководство оператора

Страница: 11 / 52

11 – English
WARNING:
Do not connect to power supply until assembly is
complete. Failure to comply could result in accidental
starting and possible serious personal injury.
ASSEMBLY
INSTALLING THE DIPSTICK
See Figure 3, page 17.
The air compressor has a label installed between the oil fill
hole and a travel cap. Before using the unit the first time,
remove travel cap and label and insert supplied dipstick.
Make sure to add oil before first use. See
Checking the Oil
before first time operation.
OPERATION
DANGER:
Drain air from tanks prior to disassembling the
check valve, drain valve or safety relief valve.
WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict severe injury.
WARNING:
Always wear eye protection with side shields
marked to comply with ANSI Z87.1. Failure to do
so could result in objects being thrown into your
eyes resulting in possible serious injury.
WARNING:
This equipment incorporates parts, such as snap
switches, receptacles, and the like that tend to
produce arcs or sparks and, therefore, when
located in a garage, it should be in a room or
enclosure provided for the purpose, or should be
18 in. or more above the floor.
WARNING:
Do not attach any tools to the open end of the hose
until start-up has been completed.
CAUTION:
Do not use in an environment that is dusty or
otherwise contaminated. Using the air compressor
in this type of environment may cause damage to
the unit.
APPLICATIONS
Air compressors are utilized in a variety of air system
applications. Match hoses, connectors, air tools, and
accessories to the capabilities of the air compressor.
You may use this product for the purposes listed below:

Operating some air-powered tools

Operating air accessories such as air nozzles and
automotive tire inflators
CHECKING THE OIL
See Figures 3 - 4, page 17.
Always check the oil when the unit is sitting on a level surface
and before first use.
To check the oil level using the sight glass:

The sight glass is located below the oil fill hole. There is
a red dot in the center of the glass.

An oil level at the top of the red dot indicates oil is at
maximum level.

An oil level at or below the bottom of the red dot indicates
oil is below desired level, and oil should be added.
To check the oil level using the dipstick:

Insert the dipstick into the oil fill hole completely. Remove
the dipstick and check the oil level.
 Make sure the reading is between the MIN and MAX
reference levels on the dipstick.
NOTE: Never let the oil drop to a level lower than MIN.
Maximum level is reached when the oil reaches the MAX
level reference on the dipstick.
 Reinsert the dipstick securely into the oil fill hole.
To add oil:

Remove the dipstick.

Using a funnel, carefully pour oil into the oil fill hole. Refill
only with synthetic oil SAE 5W40.
NOTE:
Avoid using too much oil. Ensure that the level of
the oil does not exceed the maximum reference level on
the dipstick.

Reinsert the dipstick securely into the oil fill hole.