Remove the batteries prior to long term stor-
age to avoid battery leakage.
1. Squeeze the battery clips
(See Figure
3) and remove battery compartment from
the micro CA-100 Inspection Camera
(See Figure 4). If needed, remove batter-
ies.
Figure 3 – Battery Compartment Cover
2. Install 4 new AA alkaline batteries (LR6),
observing the correct polarity as indi-
cated on the battery compartment. Only
replace in sets to help prevent battery
leakage.
3. Squeeze the clips and firmly insert into in-
spection camera. The holder will only go
in one way. Do not force. Confirm se-
curely attached.
Figure 4 – Battery Compartment
Installing the Imager Head
Cable or Extension Cables
To use the micro CA-100 Inspection Camera,
the imager head cable must be connected
to the handheld display unit. To connect the
cable to the handheld display unit, make sure
the key and slot
(Figure 5) are properly
aligned. Once they are aligned, finger tighten
the knurled knob to hold the connection in
place.
FCC Statement
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reason-
able protection against harmful interference in
a residential installation.
This equipment generates, uses, and can ra-
diate radio frequency energy and, if not in-
stalled and used in accordance with the in-
structions, may cause harmful interference
to radio communications.
However, there is no guarantee that interfer-
ence will not occur in a particular installation.
If this equipment does cause harmful interfer-
ence to radio or television reception, which
can be determined by turning the equipment
OFF and ON, the user is encouraged to try to
correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equip-
ment and receiver.
• Consult the dealer or an experienced
radio/TV technician for help.
Electromagnetic
Compatibility (EMC)
The term electromagnetic compatibility is
taken to mean the capability of the product to
function smoothly in an environment where
electromagnetic radiation and electrostatic
discharges are present and without causing
electromagnet interference to other equip-
ment.
The RIDGID micro CA-100 Inspect-
ion Camera conforms to all applicable EMC
standards. However, the possibility of it caus-
ing interference in other devices cannot be
precluded.
Tool Assembly
WARNING
To reduce the risk of serious injury dur-
ing use, follow these procedures for
proper assembly.
Changing/Installing Batteries
T
he micro CA-100 is supplied without batter-
ies installed. If the battery indicator displays
red , the batteries need to be replaced.
5
micro CA-100 Inspection Camera
NOTICE
www.
GlobalTestSupply
.com
Find Quality Products Online at:
