RIDGID JP06101, Руководство оператора

Страница: 17 / 104

17
ASSEMBLY
ASSEMBLING HANDWHEEL
See Figure 21.

Locate the following:
Pan Head Screw with Washer, 1/4-20 x 5/8 in. ........1
Handwheel ................................................................1

Slip the handwheel onto the infeed table elevation shaft
and install the pan head screw with washer as shown.
ASSEMBLING DUST CHUTE
See Figure 22.

Locate the following:
Sawdust Chute ........................................................1
Wing Screws, 1/4-20 x 1/2 in. .................................2
Wrench Box, 8mm/10mm ........................................1
Hex Key, 3mm .........................................................1

Slide the tab on the bottom side of the dust chute into
the slot just below the chute on the left side of the base.
Fasten the dust chute on with wing screws through the
slots on both sides of the dust chute.

The hex key and open end wrench (supplied with the
jointer) used for knife adjustments, can be conveniently
stored in the dust chute as shown.
NOTE: If a dust collection system is not in use, simply
loosen the wing screws, lift the bottom of the chute up,
out, and then slide the dust chute up and retighten the
wing screws.
ASSEMBLING FENCE ASSEMBLY TO
BED ASSEMBLY
See Figure 23.

Locate the following:
Washer,1/2 in. ...........................................................1
T-Nut .........................................................................1
Fence Assembly .......................................................1
Fence Lock Knob......................................................1
Fence Tilt Knob .........................................................1
NOTE:
While installing the fence, the two ribs on top of the
fence indicate where the cutter head opening is located
in the table.
NOTE:
While installing fence to table, do not remove the
protective cutter guard covering.

Position fence onto fence support as shown, making sure
the keyway in fence assembly lines up with the key on
the fence mount.

Once fence is in place, slide the fence lock knob through
the 1/2 in. washer and then through the fence assembly
and fence mount. Thread T-nut onto the end of the lock
knob. Make sure the tabs on the nut sit in the slot on the
fence mount.
NOTE:
Tabs on T-nut must be positioned upwards so
they fit in slot.

Slide the fence back and fourth to make sure it moves
freely. Then lock in place.

Thread the fence tilt knob into the fence.
HANDWHEEL
PAN HEAD
SCREW
ELEVATION
SHAFT
DUST CHUTE
WING SCREW
FENCE
ASSEMBLY
FENCE MOUNT T-NUT
FENCE LOCK
KNOB
Fig. 23
Fig. 21
Fig. 22