Emptying the Dust Drum
1. Unplug Power Cord from power source.
2. Remove the Powerhead Assembly by
pulling outward at the top of the two
Latches.
3. Lift Powerhead Assembly from the
Dust Drum and set aside.
4. Empty Dust Drum into a proper waste
disposal container.
3. (Optional) Attach the Extension Wand
to swivel end of the Hose.
4. Turn the Vac on and you are ready to
use your Vac as a Blower.
Blowing Feature
Your Vac features a Blowing Port. It can
blow sawdust and other debris. Follow the
steps below to use your Vac as a Blower.
1. Locate the Blowing Port, at the rear of
the Powerhead of your Wet/Dry Vac.
2. Insert the larger end of the Tug-A-
Long Positive Locking Hose with Dual-
Flex into the Blowing Port of the Vac.
Engage the Hose Latch to the lip of the
Blowing Port. The Hose should snap
into place.
WARNING: To reduce the risk
of injury from accidental starting,
unplug power cord before emptying
the drum.
!
OPERATION
10
Dust
Drum
Drum
Latches (2)
WARNING: Always wear safety
eyewear complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before
using as a blower.
CAUTION: Wear a dust mask if
blowing creates dust which might
be inhaled.
WARNING: To reduce the risk
of injury to bystanders, keep them
clear of blowing debris.
!
!
!
Extension Wand
(Optional)
Swivel
End of
Hose
Hose
Blowing
Port
Tug-A-Long
Positive Locking
Hose with
Dual-Flex
SP7072 HD06001 HD09001 ESF_HD06001 HD09001.indd 10
7/10/18 2:07 PM
