OFF
ON
Pre Ride Inspection
2. Turn “ON” the ignition key
First assure that the throttle is not rotated forward to start your scooter.
Insert the ignition key and turn clockwise to the “ON” position.
You can confirm your action by looking at the dash. A “RED POWER ON” light will appear
and the Battery Charge Level Indicator needle will move to the available battery level.
If your battery level is in RED region please follow the procedure on Battery Charging
Process. If the RED POWER ON light does not appear make sure the Main Power Breaker
located under the riding seat is in the “ON” position.
!
WARNING
3. Electrical System Check: Signals, Brake Lights and Horn
Turn signals:
Perform a complete electrical inspection. Test turn signals
left and right. Position the turn signal switch left view turn signal lights
on the front and rear of the scooter. Move turn signal switch to the right
and perform the same visual inspection. Note: Your turn signal switch
latches, and continues to flash in either the left or right position. Simply
push the switch inward to release the standard latching function.
With the ignition switch in the “ON” position your scooter is now
fully functional. EXTREME CAUTION must be taken NOT TO
twist the throttle. This could cause an unplanned movement
of the scooter. Carefully go through all checks and
inspections with care and caution.
Ignition Switch
Three Positions
OFF, ON and Lock
Battery Charge Level
Ignition ON Indicator Light
Main Power Breaker Switch
Test brake lever action and assure brake lights function properly.
Turn the ignition key to the ON position. Squeeze brake lever, view rear
brakes lights for to assure their proper ON function when either front or
rear brake lever is squeezed.
Horn:
You horn can be checked on either side of the handle bars.
Test each sides horn switch for proper function.
15
