Ridder 507501, Руководство по эксплуатации продукта

Страница: 19 / 28

Ridder Drive Systems T
+31 (0)341 416 854
F
+31 (0)341 416 611
I
www.ridder.com
19
The following conditions apply to erasing an end position:
● The end position to be erased (A or B) must have been programmed (see §6.1).
6.3 Teaching in the LogicDrive RLD200 - Erasing an end position
u
Description Picture
1
Set DIP switch S1 to ‘Teach-in mode’.
Depending on the situation, ‘LED A’ and ‘LED B’ will blink
according to a certain blink code (see §8.1).
2-A
To erase end position A, first press and hold down the
programming button ‘PROG’ (①) and then press the
control button ‘DIR A’ (②). Release both buttons once
the corresponding ‘LED A’ starts blinking faster (③).
Remarks:
● End position A can be erased while in any position!
● The blink code for ‘LED B’ may be different.
2-B
To erase end position B, first press and hold down the
programming button ‘PROG’ (①) and then press the
control button ‘DIR B’ (②). Release both buttons once
the corresponding ‘LED B’ starts blinking faster (③).
Remarks:
● End position B can be erased while in any position!
● The blink code for ‘LED A’ may be different.
3
The end position/positions and the taught-in emergency position have now been erased.
Re-program the end position/positions and the emergency position (see §6.1 and §6.2).
If an emergency position has been programmed,
it will also be cleared when an end position is erased!