Ricoh U-C1 B051, Руководство по обслуживанию

Страница: 160 / 343

26 July 2002 SERVICE CALL
4-9
Trouble-
shooting
No.
Definition
Symptom Possible Cause
Fusing oil end 570 A
500 sheets of paper have been output
since oil end was detected.
•
Insufficient oil (the oil tank in the rear of
the machine)
•
Defective oil pipe
•
Defective oil pump
•
Defective oil end sensor
Fusing oil overflow 571 A
•
The oil overflow sensor detects oil.
•
When the machine covers are
closed, the oil supply unit is not
detected.
•
When the machine covers are
closed, the fusing unit is not
detected.
•
Defective oil end sensor
•
Defective oil overflow sensor
•
Defective sensor cable
•
Oil supply unit not installed
ADF communication error 620 D
The ADF has been detected.
→
A
communication error has occurred.
•
Loose connection
•
Defective ADF
•
Defective BICU board
•
Defective scanner I/O board
•
External noise
CSS communication error 630 C
The machine tries to communicate
with one of the terminals of a relevant
service center.
→
An error signal
returns.
•
Communication error on the public
telephone network (logged only; the
machine can still operate)
MF accounting device error 1 632 D
The machine sends a data frame.
→
No normal end signal returns.
→
This
symptom happens three times.
•
Defective or broken line between
machine and device
MF accounting device error 2 633 D
The machine is communicating with
the accounting device.
→
The break
signal returns.
•
Defective or broken line between
machine and device
MF accounting device error 3 634 D
A backup RAM error is reported from
the accounting device.
•
Defective accounting device controller
•
Defective battery in the accounting
device
MF accounting device error 4 635 D
A battery voltage error is reported
from the accounting device.
•
Defective accounting device controller
•
Defective battery in the accounting
device
Engine-to-controller communication checksum error 640 C
While the BICU and controller are
communicating, a checksum error
has occurred.
•
Logged only; the machine can still
operate
Engine-to-controller response error 641 D
The controller has sent a frame with
the RAPI protocol, but the engine
does not respond.
•
Defective controller board
•
External noise