Ricoh TC-II, Руководство по эксплуатации

Страница: 37 / 64

User Tools
27
2
8 Jump Table You can change the angle of the wing guide depending on the pa-
per type you use.
Note
❒
Default: Auto
❒
Available settings:
• Up (Select this setting when standard thickness or thin pa-
per misfeeds at the paper exit section occur frequently.)
• Down (Select this setting when A4-B5, 8
1
/
2
"
×
11" thick pa-
per is not delivered properly to the paper delivery tray.)
9 Drm Stp Mode You can select the drum which you will be able to pull out imme-
diately after you finish your job without pressing any key.
Note
❒
Default: Drum 1
10 Long Sheet Mode You can select whether you can use paper longer than
432mm,17.0" or not.
Note
❒
Default: Not to use
❒
When you use paper longer than 432mm, 17.0”, lower the pa-
per delivery end plate and receive completed prints by hand.
11 Skip Number of
Time Specifies the number of drum rotations in Skip Feed mode when
the power is turned on.
You can also select whether you can change the number of drum
rotations temporarily when you press the
{
Skip Feed
}
key.
⇒
P.23
“Skip Feed Printing”
Note
❒
Default:
• Number of Skip Feed: 2
12 Skip Display On
Mode When you press
{
Skip Feed
}
key, you can select whether optional
print counts display shows up or not.
Note
❒
Default: Off
13 Total Counter
Down The copy counter can be set to show the number of copies made
(Count Up), or the number of copies remaining to be made
(Count Down).
Note
❒
Default: Yes (Count Down)
14 Print Position You can register the settings of print image position.
15 Feed Setup You can register the settings for frequently use.
No. Mode Description