Ricoh SR4110, Руководство по обслуживанию на месте

Страница: 51 / 60

2.Replacement and Adjustment
47
Punch Unit
Punch Position Adjustment
The position of the punched holes can be adjusted in two ways.
•
Front to Rear Adjustment
Three spacers [A] are provided with the punch unit for manual adjustment of the hole position in the main
scan direction:
•
2 mm (x 1)
•
1 mm (x 2)
•
One spacer was installed at installation and the remaining spacers were fastened with a screw to the
rear frame of the finisher under the rear cover and slightly above the lock bar.
•
Right to Left Adjustment
The position of the punched holes can be adjusted right to left in the sub scan direction with SP6101 Punch
Hole Position Adjustment. The position can be adjusted in the range ±7.5 mm in 0.5 mm steps. The default
setting is 0.
Press the key to toggle the ± selection. A +ve value shifts the punch holes left toward the edge of the
paper, and a -ve value shifts the holes right away from the edge.