Ricoh OP-MF1, Обучение по обслуживанию

Страница: 124 / 125

124
OP-P1/MF1 Training
Slide 124
Energy Saving
Overview
10 s Off or 30 s only Off Energy Saver Mode 1
25 s See below 1 min. Energy Saver Mode 2
Recovery time Setting range Default Mode
Timer settings and recovery time (Smart Organizing Monitor

User Tool

Printer Configuration

System tab)
Power
Operating
Stand-by Mode
Warm-up
Energy Saver Mode 1
Energy Saver Mode 2
Energy Saving
Cold Start
Timer starts
Time
After 240min.
From last job
Energy Saver Mode 2 timer
Setting range: See below
Energy Saver Mode 1 Timer
30 sec.
Energy Saver Mode 2: Setting Range
For -17 (NA, Brazil) and -21 (China): 1-240 min.
For -27(Europe, Asia, part of South America): 1-30 min.

When the machine is not being used, the machine enters energy saver mode to
reduce the power consumption by turning off the LCD of the operation panel and
lowering the fusing temperature.

The area shaded grey in this diagram represents the amount of energy that is
saved when the timers are at the default settings. If the timers are changed, then
the energy saved will be different. For example, if the timers are all set to 240
minutes, the green area will disappear, and no energy is saved before 240
minutes expires.

If the operator prefers that these settings be changed or switched off altogether,
please explain that switching these energy saver features off could increase
energy costs and waste energy.

If the operator changes the settings please advise that setting Energy Save
Mode 2 should not be too long. The longer the machine waits to enter Energy
Save Mode 2, the more energy will be wasted.

Setting Energy Save Mode 2 to the maximum value (240 min.) should be
avoided. At close of business for the day, the machine will wait 4 hours before
entering Energy Saver Mode 2. This is a waste of energy.

Energy Saver Mode 1 cannot be turned off.