8
Rear panel
1. Analog Audio Output Connector
Provides output to a sound card (Analog signal).
2. Jumper Connector
This jumper determines whether the drive is configured as a master or slave. Changing the master-
slave configuration takes effect after power-on reset.
3. IDE Interface Connector
Connect to the IDE (Integrated Device Electronics) interface using a 40-pin flat IDE cable.
Caution
Do not connect or disconnect the cable when the power is on, as this could cause
a short circuit and damage the system. Always turn the power OFF when
connecting or disconnecting the cable.
4. Power Connector
Connects to the power supply (5 and 12V DC) of the host computer.
Caution
Be careful to connect with the proper way.
Connecting the wrong way may damage the system (and is not guaranteed).
