Container Stacker Installation Instructions 1-33
Adjustment
Adjust paper feed position of Hopper 1
1.
Print the same size paper from Hopper 1 and Hopper 2 and check the paper feed-
ing position.
2.
If the configuration includes Container Stacker 1, check the paper feeding
position on the sample tray.
3.
If the configuration includes Container Stacker 2, open the top cover of Container
Stacker 2, insert the cheater found in the Printer accessory box) in the interlock
switch, and check the paper feeding position on the slit between Paper Guides.
4.
Set a standard point in the sample tray and the frame of the Container Stacker and
check the gap of the paper feeding position between Hopper 1 and Hopper 2 and
whether the paper is closer to the front side or the rear side.
a.
When the paper from Hopper 1 is closer to the front side compared with the
paper from Hopper 2, there is no need to add a Hopper spacer.
b.
If the paper from Hopper 1 is closer to the rear side by 1-2 mm compared with
the paper from Hopper 2, add 1 piece of Hopper spacer at each location as
shown in below.
Содержание Container Stacker
Страница 5: ...ii Table of Contents ...
Страница 49: ...A 10 Installation Maintenance Area ...