Ricoh BOOKLET MAKER BK5010, Руководство по установке

Страница: 14 / 74

1-10
04 October 2007 BOOKLET MAKER INSTALLATION
1. Remove the finisher rear cover ( x 2).
2. Open the finisher door and pull out the stapling tray.
3. Remove black plastic covers [A] at the bottom of the finisher (
x 2).
4. Install the docking assembly [B] in the holes under the black plastic covers [A].
NOTE: Both nuts [C], installed on the docking assembly, have different
diameters on each side of the nut. A big diameter [D] on one side,
and a smaller diameter [E] on the other.
5. Secure the docking assembly with the two nuts [C], using the multi tool.
Mounted correctly, there shall be less than 1mm play in the Docking assembly.
NOTE: The Multi tool ( 3.2 ) is located behind the rear cover of the Book-
let maker ( x 5).
NOTE: Make sure to fit the nuts in the correct position. The bigger diam -
eter should fit in the hole nearest the rear side [F] of the finisher.
The smaller diameter should fit in the hole nearest the front side
[G] of the finisher.
Docking assembly
[A]
[B]
[C]
[D]
[E]
[F]
[G]
Finisher seen from front side
Finisher seen from above