Ricoh Bc-C1, Руководство по обслуживанию на месте, Страница: 102 / 268

10. Set the coupling [A] back to the shaft.
11. Turn the coupling in the direction of the arrow [B] to remove developer from the roller.
12. Turn the bottom part [C] over and rotate the gears to remove the developer.
13. Load new developer.
14. Reassemble the PCDU.
15. Install the PCDU in the machine.
16. Reassemble the machine.
17. Plug in and turn on the main power switch of the machine.
18. Execute SP2-801-001 (Deve Initializati Init TD Sen Execu) to reinitialize the TD sensor.
• Make sure no toner or developer stays on the gear. Clean the gears as necessary with a
blower brush, etc.
• Be sure to replace the Mylar at the rear side in the correct position. (The Mylar protects the
gears at the rear side from falling toner).
4. Replacement and Adjustment
100
Also see RTB 3