Ricoh AC205, Руководство по обслуживанию

Страница: 172 / 188

ENGINE
B273 6-18 SM
6.5.2 DRIVE
The Main Motor drives the following:
•
Paper feed unit
• Developing unit
•
Fusing unit
Software drives the Main Motor and controls the motor acceleration, motor speed,
and motor de-celeration. The motor is managed via an A3977 driver IC and is con-
trolled by signals from the CPU.
6.5.3 TRANSFER
The charging voltage, developing voltage, and the transfer voltage are controlled
by PWM (Pulse Width Modulation). Each output voltage is variable according to the
PWM duty cycle. The transfer voltage used when the paper passes the transfer
roller is decided by environment recognition. The resistance value of the transfer
roller changes due to the surrounding environment in the room or within the set.
This change in resistance in turn changes the value of the voltage, due to loading.
This voltage is fed back into the set through the A/D converter. Based upon this
fed-back value the PWM cycle is changed to maintain the required transfer voltage.
6.5.4 FUSING
The temperature of the heat roller's surface is detected from the resistance value of
the thermistor. The thermistor resistance is measured with the A/D converter. This
allows the CPU to determine the temperature of the heat roller.
The AC power is controlled by comparing the target temperature to the value from
the thermistor. An error appears if the value from the thermistor is out of the control
range during the fusing process. The table below shows the error conditions.
Error Description
Open heat error
The temperature remains lower than 68
°
C for more than 25 seconds
during warm-up.
Low heat error
Standby: The temperature remains lower than 100 ° C for more than 25
seconds.
Printing:
1. The temperature remains lower than 145 ° C for more than 5
seconds for 2 consecutive pages
2. The temperature remains 40
°
C lower than the fixed fusing
temperature for more than 4 seconds, for 3 consecutive pages.
Over heat error
The temperature remains higher than 220
°
C for more than 3 seconds.