13. Gently tug on the wires to insure they are fully
seated and will not come out. Be sure the metal jaw
on the terminal block is contacting the metal strands
of the wire.
14. Lay the pedal on the pedal housing and screw the
ground terminal to the pedal base as shown. Then plug
the three wires onto the corresponding terminals on the
LC27-2 interface board.
Note:
If the load cell kit is for use with a Thrustmaster
wheelbase then the circuit board will be missing some
electronic components and the connection posts will be
re-labeled.
15. Lay the pedal back into position in the housing.
Using the wire ties, strap the load cell wire to the
original pedal wiring as indicated by the circles above.
Peel off the backing on the mounting pad on the back
of the interface board and secure to the plastic base as
shown.
16. Make sure the cable exiting the housing is routed
properly through the posts.
17. Place the bottom cover back on the housing and be
sure it drops into place evenly all the way around.
