Rickard BW2011-2B, Руководство пользователя

Страница: 21 / 26

21
RICKARD 2019
MLM INTEGRATION WITH BMS
 Wallstat

Expand the diffuser icon in the Logical screen and select the Wallstat (type code 7).

Under Setup/Unoccupied delays, verify and edit the delay 1 & delay 2 periods. Note the default of
900 seconds for a 15 minute delay.
 Check and edit the Process/Setpoint/BackoffBand setting. The default is 1.8 °C.

Check and edit the RTC/Afterhours Backoff Band setting. The default is 1.8 °C.

Under Master Command, check and write the control override parameter.
Note: The three parameters of interest in setting up occupancy sense are:
 Occupancy present as set on the Diffuser controller – this enables/arms that particular sensor to be active.

Unoccupied delays – setting these timers to zero will stop the timers and the controller unit (Wallstat or
On-board) will always indicate the zone as occupied.

Control override – by unchecking this box, the controller unit will still show the occupied status, but will
not command the Diffuser controllers into a back-off state.
Note: Occupancy present will be selected on all Diffuser controllers that are factory fitted with occupancy sen-
sors.

On-board master

Expand the diffuser icon in the Logical screen and select the On-board master (type code 8).

Under Setup/Unoccupied delays, verify and edit the delay 1 & delay 2 periods. Note the default of
900 seconds for a 15 minute delay.

Check and edit the BackoffBand setting under Setpoint. The default is 1.8 °C.

Under Master Command, check and write the control override parameter.