Rice Lake RL1800 Series, Руководство по установке

Страница: 10 / 16

RL1800 Series Weigh Module Kit
6 Visit our website
www.RiceLake.com
4. Lift and block the vessel to the same height as the assembled modules.
5. Lift one corner or side of the vessel enough to slide that module into place.
6. If the module is being fitted under the leg of a vessel, verify the leg’s center line
passes through the center of the top plate (and center of the load cell’s load hole).
7. Secure top plate by bolting, do not fully tighten, shimming may be needed to level.
8. Repeat steps 5, 6 and 7 for the remaining modules. The vessel is now supported on
the modules only.
9. Move the vessel to its final position, if necessary.
10.Verify that there is no initial misalignment between the base plate and top plate by
lifting the vessel slightly at each support point in turn. This also indicates if the load
is evenly distributed on all modules.
11.Shim as needed (this only applies to systems utilizing more than 3 modules).
12.Attach the base plates to the foundation using anchor bolts for concrete or by
bolting or welding to a steel structure.
13.Verify that the base plates are no more than ±0.5

out of level. Shim if needed.
14.Check that the top plates are no more than ±0.5  out of level. Shim if needed.
15.Tighten the bolts.
16.Check the load distribution by connecting each load cell to the junction box and
indicator in turn and measuring the output with a voltmeter. To verify wiring scheme,
check the installation manuals for the junction box and indicator. The variation in
load among the cells should be no more than 20%. Shim if needed.