Rice Lake REVOLUTION Tracer AV, Руководство по установке, Страница: 12 / 48

8 Tracer AV Installation Manual
There are two socketed DB-9 connectors for remote displays which are connected to the serial port J4. The
remote display’s DC power and communications are run in the same three-conductor cable. The serial port data
is transmitted on the 20 mA pins to the remote displays.
2.3.4 Digital I/O
Digital inputs can be set to provide several indicator functions, including all keypad functions. In the Tracer AV ,
these inputs are set to
Zero
and
Units
for the remote keypad. The inputs are active (on) with low voltage (0 VDC)
and can be driven by TTL or 5V logic without additional hardware. LEDs on the CPU board light when digital
inputs are active.
Digital outputs are typically used to control relays that drive other equipment. In the Tracer AV , the setpoint value
will cause the display to flash. Outputs are designed to sink not source, switching current. Each output is a
normally open connector circuit, capable of sinking 250 mA when active. Digital outputs are wired to switch
relays when the digital output is active (low, 0 VDC) with reference to 5 VDC supply. LEDs on the CPU board
light when the digital outputs are active.
DB-9 EDP Port
COMM J3 Function Pad
Pin 2 1 EDP TxD P 1
Pin 3 2 EDP RxD P 2
Pin 5 3 EDP Gnd P 3
Table 2-2. EDP Port/COM
DB-9 Serial Port Digital Output
Remote J4 J6 Function Pad
n/a 4 +5 VDC P 4
n/a 4 20 mA+ P 5
n/a 5 20 mA- P 6
Pin 1 +7.5 VDC n/a
Pin 2 Gnd n/a
Pin 9 TxD n/a
Table 2-3. Serial Port/Remote Display
DB-9
Digital Input
J2 J12 Function Pad Number
Pin 4 1 Setup P 10
Pin 5 3 Gnd P 7
Pin 8 1 Dig In 1 P 9
Pin 9 2 Dig In 2 P 8
Table 2-4. Digital Input/Remote Keypad
Port Connector Pin Function
Digital
Output J6 1 Gnd
2 DO 1
3 DO 2
4 +5V
Table 2-5. J6 Digital Outputs