880 Relay Option Card Installation
4
Visit our website
Universal Mount Installation
1. Disconnect power to the indicator.
2. Remove the backplate of the enclosure as instructed in the 880 technical manual (158387) to access the CPU board.
3. Carefully align the J5 connector on the bottom of the option card board with the J8 connector on the 880 CPU board.
Figure 6. Option Card Board Installation
4. Press down on the option card board until it is seated on the 880 CPU board connector.
5. Use three provided option kit screws to secure the option card board to the threaded standoffs on the 880 CPU board.
The provided faceplate is not needed when installing the option card inside of the 880 universal enclosure.
6. Route and connect necessary cable(s). See
on page 5 for additional information.
7. Shield ground the cable(s) using a cable clamp, washer and nut provided in the option card kit and a grounding stud
on the enclosure.
See the 880 technical manual (158387) for additional information on shield grounding.
8. Secure the backplate and then reconnect power to the indicator.
9. If needed, see the 880 technical manual (158387) for additional information on Relay configuration.
SLOT 1 must be configured in the Setpoints Menu (SETPTS) and BIT 1-4 in the Digital I/O Menu (DIGIO) within the
Setup Menu of the 880 indicator for the desired output.
Threaded
Standoffs
J8
Connector
Note
Note
Note
