This electric tool is in accordance with the relevant safety requirements. Repairs should only be
carried out by qualified persons using original spare parts, otherwise this may result in considerable
danger to the user.
23. Remarks:
The safety precautions and instructions given in this manual are unable to cover in detail all the
conditions and situations that may arise.
The operator and/or user must use common sense and caution when operating the product especially
for any matters that are not referred in the above
SPECIAL WARNINGS WHEN USING THE PRODUCT
1. Become familiar with the controls and the proper use of the equipment.
2. The use of this product by children is forbidden.
3. Only well-instructed adults should operate the product. This product is not intended for use by
persons (including children) with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or instruction concerning use of
the product by a person responsible for their safety.
4. Use only accessories with a permissible speed at least as high as the no-load speed of the machine.
5. Do not use tool if damaged, eccentric or vibrating.
Start operating tool with mixing blade inside material.
6. Observe the rotating direction.
Always hold tool firmly to avoid kickbacks.
7. Never seize or touch the shaft of mixing blade during operation
8. Always stop the tool before putting it down (note: Ensure that mixing blade is no longer moving
when you put down the tool)
Warning! The mixing blade continues to rotate after releasing the switch. Ensure that mixing blade
come to a stop before putting down product.
9. If the power cable is damaged, it must be replaced by the manufacturer, its after sales service or a
person with similar qualification in order to avoid any danger.
If the power cable or extension cord is damaged or cut during operation, immediately disconnect plug
from its main power source. Do not touch the cable or extension cord before unplugging from main
power.
IV. GETTING STARTED
Before any intervention on product, ensure that product is disconnected from its
power source.
Installing the Shaft and Mixing Tool
1- Take both parts: shaft and mixing tool (Fig. D).
2- Assemble both parts (Fig. E).
3- Tighten with a wrench (Fig. F)
4- Insert mixing tool in mixer (Fig. G)
5- Tighten with a wrench (Fig. H).
Note : Before use and during use, periodically check the hex screw is securely tighten
Fig. D
Fig. E
Fig. F
Fig. G
Fig. H
