Kickback will propel the tool in the direction opposite to the blade’s movement at the point of
snagging.
d- Use special care when working corners, sharp edges, etc. Avoid bouncing and snagging the
accessory.
Corners, sharp edges or bouncing have a tendency to snag the rotating accessory and
cause loss of control or kickback.
IV. GETTING STARTED
Before any intervention on product, ensure that product is disconnected form its
power source.
4.1- Unpacking
- Remove product from its packaging.
- Check that tool and accessories are not damage
4.2- Content
- 1 jigsaw
- 3 blades
- 1 dust extractor connector
- 1 cutting guide
- 1 notice
4.3- Instant response operation
(Fig. B)
Switching on .... : Press the On/Off switch (3)
Switching off .... : Release the On/Off switch (3)
4.4- Continuous operation
(Fig. B)
Switching on .... : Press the On/Off switch, keep depressed and
then lock with the locking button (4)
Switching off .... : Press the On/Off switch (3) and release it.
Fig.B
4.5- Electronic speed control setting
(Fig. B)
Turn the speed selector in (+) direction to increase speed and turn it in (-) direction for a lower
speed. The ideal cutting rate depends on the specific material and working conditions.
The general rules for tool speed in cutting operations apply.
4.6- Laser cutting guide
Switching on ..... : Press the On/Off switch (1)
Switching off .... : Press the On/Off switch (1)
4.7- Changing the saw blade
(Fig. C)
Remarks
:
-
Switch off the jigsaw and remove the plug from the power socket before changing the
blade or carrying out any other work on the jigsaw.
-
Wear protective gloves to avoid any injury while handling the blade.
-
Only fit blades with “T” type tail.
-
Clean the blade tail before assembly.
