Page
33
/
36
Fig.3
Fig.3a
Fig.3b
4.3- Mandrino manuale
4.3.1- Inserire un accesorio
1. Aprire il mandrino con la chiave
2. Inserire l’accesorio fino alla battuta nel mandrino e bloccare con la chiave.
3. Garantire il bloccaggio sicuro tirando con forza su l’accesorio.
4.3.2- Rimuovere l’accesorio
1. Per rimuovere l’accessorio, aprire il mandrino con la chiave.
2. Rimuovere l’accessorio.
3. Pulire l’accessorio e lubrificare leggermente con grasso per macchine
4.4- Montare l’impugnatura aggiuntiva (Fig.4)
Pericolo di ferimento!
Mai inserire la spina nella presa quando monta o rimuove l'impugnatura.
Utilizzare il martello perforatore, per motivi di sicurezza, sempre e solo con l’impugnatura
aggiuntiva
1. Allentare il serraggio dell’impugnatura aggiuntiva (10) con
due-tre rotazioni dell’impugnatura in senso anti-orario (verso
sinistra).
2. Far passare il serraggio sopra il mandrino e collocarlo sul corpo
del trapano.
Girare l’impugnatura aggiuntiva nella posizione desiderata.
3. Fissare nuovamente l’impugnatura aggiuntiva girando
l’impugnatura in senso orario.
Fig.4
4.5- Limitatore di profondità (Fig. 5+6)
Il trapano è munito di una battuta di profondità (11) che serve per
praticare fori della profondità desiderata.
Nota : La battuta di profondità è consigliabile solo per lavori di
perforazione o senza percussione.
1. Allentare il dado ad alette [a] sul serraggio dell’impugnatura
aggiuntiva (10) fino a quando l’apertura [b] è liberata.
2. Inserire il limitatore di profondità (11) nell’apertura [b].
3. Regolare il limitatore di profondità.
4. Avvitare il dado ad alette [a] al serraggio dell’impugnatura
aggiuntiva (10).
5. La punta adesso non potra penetrare mai nel materiale da perforare
quando il limitatore di profondità urta nel materiale da perforare.
Fig.5
Fig.6