ruling national standards and local regulations.
- Check available power supply data
- Observe pump name plate data
- Power supply fuses: 10A, inert action
- Baseplate (on site by others) to be earthed
- Degree of protection: IPX5
- The pump motor is internally equipped with thermal overload contacts (WSK).
Ensure that respective terminals are available in the filter switch-box.
4.4.3- Terminals
Effect on-site wiring according to the following wiring diagram.
Fig.4
SWIM370/1,SWIM550/1,SWIM750/1
a- Capacitor; b- Electric power cord
4.5- Commissioning
- Pool and balance tank (if applicable) must be filled
- Close all insolating valves
- Undo cover nut (3) of the strainer assembly with the ring spanner and remove the strainer cover (4).
ATTENTI0N! The line strainer must be filled with water after draining the pipe system. This ensures
priming ability of the pump in case of filter plant installation above pool water level.
- Reposition of lint strainer cover (4) and secure by tightening with the ring spanner.
ATTENTION! Pump must never be on without a lint strainer (9)!
- Open isolating valves.
- Switch on pump or switchbox respectively.
- If using switch gear with integral electronic overload control, it must be adjusted to the full load
current value of the motor.
- Dry running for a short period will not damage the pump. However, dry running for a long time is
not recommended.
V- OPERATION
5.1- Intended use
- Swimming pool pumps are pumps intended for domestic use, for private swimming pools.
- The product is intended for pumping swimming pools water.
- The pump is resistant to chemicals commonly used to treat swimming pools water. Nevertheless, it
does not resist to sea water or salted water
5.2- Tips
1. The pump must be positioned horizontally, ensure that it is stable during operation.
Suction holes should never be blocked.
Warning! Never run dry the pump.
2. If the discharge stops while the pump continues to run, immediately cut the power.
Unplug from socket and check the cause of the problem.
