RIB ACG8042, Руководство пользователя, Страница: 17 / 36

17
G
B
2
12
6
1
7
11
5
4
3
9
10
8
DLRX
S3
SWRX
J2
BAT
5
6 8
+
-
7
INFRARED SIGNAL RECEIVER - RX
RX
RECEIVER
SETTINGS AND
CONNECTIONS
J2 Connector
for connecting the
receiver diode
BAT Alkaline batteries
2 x AA 1,5V
SWRX Micro-switches for
coordination and
identification
DLRX Red LED indicating
correct power and
infrared signal alignment
S3 PROG Push-button for
memorization and
alignment
RX
RECEIVER IDENTIFICATION
Every pair of VERTIGO Wi-Fi photocells is supplied with the micro-switches in the OFF
position.
Every pair of VERTIGO Wi-Fi photocells must
OBLIGATORILY be unequivocally identified by
placing only one of the 6 different micro-switches (SWRX) on the card into the ON position.
Example: set micro-switch 1 to ON on the MASTER Wi-Fi and micro-switch 1 to ON on the
VERTIGO Wi-Fi receiver (the same DIP set on the transmitter).
ASSEMBLY OF THE INFRARED RECEIVER
- Separate the cover with the rubber support (7) from the base (8) and remove the electronic
board (9) (Fig. 6).
- Place the base (8) on the upper border of the leaf of the gate (at a maximum distance of
3 metres from the transmitter).
- Fasten it immediately using 2 self-tapping screws TCCR3,5X16 supplied
(10)
.
- Check that the gasket is present and it is intact within the cover (7) .
- If necessary, rotate the bellows assembly which includes the lens by 90°, so to direct the
infrared ray as per need (VERTIGO Wi-Fi comes with the infrared ray set as per Fig. 6). It
is possible to direct the ray according to the needs:
- Insert the electronic board already mentioned, linked to the cover with the bellow, in the
special rails on the base.
- Insert the batteries paying attention to the polarity (Fig. 8).
- When the batteries are inserted into the receiver the DLRX red led (Fig. 5) lights on for 3
seconds, indicating the proper functioning.
CARRY OUT THE STORAGE PROCEDURE
AS SPECIFIED IN THE PARAGRAPH “STORAGE”
(see next page)