22
G
B
UNCOUPLING HUB WITH AUTOMATIC RESET FOR CARBON BOOMS
(Fig. 15)
- Take the 8x7x20 latch and insert it into the seat of the hub holder shaft (Fig. 16-17).
- Assemble the hub on the shaft in the correspondence with the latch, locking it with 2
stainless steel 10x70 TCEI screws, 4 stainless steel 10x20 washers and 2 M10 self-
locking nuts (Fig.18-19-20).
CAUTION: The screws must be tightened alternately so that the hub is parallel with
respect to the hub holder shaft.
- Remove the protective plugs to the connectors located on the side of the column (Fig.
21-22).
- Connect the boom uncoupling sensor connector (Fig. 23).
- Connect the connector of motor 2 of the boom reset (Fig. 24-25).
CARBON ROD ASSEMBLY
15
16
26
19
27
21
29
23
25
18
20
28
22
30
24
17
HUB AND BOOM ASSEMBLY
- Check that the exposed surface of the boom auction is thoroughly
cleaned and that the sealing system is present at the end (Fig. 26).
- Insert the exposed part of the boom into the boom holder hub
(Fig. 27)
being careful to insert the plug at the end of the
boom, properly oriented in relation to the nylon bushing
located on the release hub (Fig. 28).
- Once the bottom is reached, rotate the boom so that the sealing
system located at the end locks in (Fig. 29).
CAUTION: The hinge of the boom cover must remain on the
side of the movement of the boom (Fig. 30).
