Rhydolabz eCee NXP LPC 2148, Быстрый старт

Страница: 15 / 16

www.rhydolabz.com
We bring the world to you..
II. MANUAL MODE
1. Configure LPC Flash Utility software at the PC side
a.
Browse your hex file here.
b. Select your COM port and Set baud rate (4800) here.
c. Disable DTR/RTS for Reset and boot loader selection.
2. Connect system serial port to COM port of eCee LPC 2148 .
3. Put jumper on ISP(J17),*ISP(J20)
4. Click “Read Device ID”
5. The software prompts you to reset the development board.
6. Press Reset button (S18) and press OK
7. Wait till Device Id is shown
5. Click “Upload to Flash” button in the flash utility software and wait till the programming is
over.
6. Remove jumper on ISP (J17),*ISP (J20)
7. Now Reset the development board