Rhydolabz eCee NXP LPC 2148, Быстрый старт

Страница: 14 / 16

www.rhydolabz.com
We bring the world to you..
PROGRAMMING STEPS
I. AUTOMATIC MODE
eCee NXP LPC 2148 development board supports two modes of programming
1. Configure LPC Flash Utility software at the PC side
a.
Browse your hex file here.
b. Select Crystal frequency here.
c. Enable DTR/RTS for Reset and boot loader selection.
d. Select your COM port and Set baud rate (4800) here.
2. Connect system serial port to COM port of eCee LPC 2148 .
3. Put jumper on RST(J21) , ISP(J17) and Reset the board
4. Click “Read Device ID” and wait till Device Id is shown
5. Click “Upload to Flash” button in the flash utility software and wait till the programming is
over.
6. Remove jumper on ISP and RST
7. Now Reset the development board