Page 6
7. Secure the passenger taillight cable to the rail of the frame with cable ties using the
pre-drilled holes in the frame. The harness should run below or behind the cross
frame so it is not pinched by the seat or body.
8. Disconnect the push-pull switch
at the 4-pin connector.
9. Route the front portion
of the harness under
the driver side of the
cart, towards the dash
compartment. Loosely
secure with cable ties.
10. Locate the rectangular hole in the
bottom of the splash guard (red
arrow). Use a utility knife to enlarge
the hole enough to fit the harness.
11. Keeping the harness on the inside
of the steering column, route the
harness through the hole in the
splash guard, one connector at a
time.
12. Make sure the headlight leads reach
the holes in the front cowl. Make
sure the push-pull switch connector
reaches the area behind the dash.
13. Remove the (4) Torx screws that hold in the front
dash.
NOTE
: The same Torx screws hold on the front cowl.
Use caution not to damage the cowl.
14. Reconnect the push-pull switch to the 4-pin
connector on the harness.
15. Tighten any cable ties left loose in this section.
To
Splash
Guard
TO DASH
Push-Pull
Switch
Headlight
Connectors
