Page 3
Strobe Light Bar Installation
1. Locate a desirable area on the top to mount the strobe light bar.
2. Using the light bar’s mounting brackets as a guide, mark the (4) mounting hole
locations onto the top using a marking device.
3. Drill through the top at the marked locations using a 10mm drill bit.
4. Fasten the strobe light bar
to the top using the included
hardware as shown. Hand
tighten.
NOTE
: At least (3) threads
on the carriage bolt should
extend out of the hex nut
once the hardware is
completely fastened. If the
bolt is too short, a longer bolt
will be required.
5. Route wires from a 12-30VDC power source to the wires on the strobe light bar.
Connect the wires following the diagram below.
NOTE
: LGT-217 wiring kit can be purchased separately for additional wires and
recommended switches (
*
12V only).
