w w w . r h o d a n m a r i n e . c o m
CUSTOMER SERVICE: 1-888-434-7726
15
6. Place the lower half of the quick release
bracket on the deck and align with the holes
drilled in the previous step. Insert the four
¼”-20x3” mounting screws from the included
hardware kit (note: it is helpful to apply a
small amount of lubricant to the threads of the
screws prior to insertion). At this point check
to see that the base is sitting flat on the deck.
If there are any gaps, or if you wish to level the
base to the boat (optional), install washers or
other spacers (not provided) as needed.
7. Once leveled, install fender washer and lock
nut onto the mounting screw and tighten to a
torque of 5 ft-lbs.
This completes the physical installation. Refer
to the following steps for electrical installation
and calibration.
