RHINO Trans TX, Инструкция по эксплуатации

Страница: 3 / 8

3
2.Changing Setting 2/Setting 1 (Inhibit mode/Enable Mode)
The intelligent TRANS TX unit can easily switch between Setting 1 ‘Enable mode’ & Setting 2
‘Inhibit Mode’.
Setting 1 ‘Enable mode’ : Allows the negative inputs to be connected, and learnt, as wires that
will arm/disarm the alarm.
Setting 2 ‘Inhibit mode’ : Allows the negative inputs to be connected to any wire that will inhibit
the arm/disarm if the input goes negative prior to, or at the same time as, the motor drive/positive
inputs. Preventing manually locking/unlocking the car from arming/disarming. This setting is the
default setting.
Carry out this procedure to toggle between the two settings.
1. Disconnect the Trans TX
2. Press and hold the button down.
3. While still holding down the button,
plug the wire harness back into the
Trans TX.
4. Once the unit is power plugged in,
the unit will give 1 flash for setting 1,
and two flashes for setting two. Simply
repeat these steps to choose between
the two settings.
Disconnect
the Trans TX.
Press and
hold the
button.
Plug in the
Trans TX
1 Flash = Setting 1
2 Flashes = Setting 2
Wait for LED
to Flash
Holding the
button in
Wait for LED
to turn on