FEATURES USED BY INSTALLERS / SERVICEMEN
1. INSTALLER / SERVICE MODE
Service mode is accessed by turning the keyswitch to the off position. Installer mode
is accessed by turning the keyswitch to off then back to the on position. The installer
test mode is used to quickly test and fault find, it is used to check each sector input
when door, hood, aux or voltage drop is triggered. A signal is given via the blinkers,
the dash LED light and the siren.
2. SHOCK SENSOR AND PREWARN ADJUSTMENT:
Th
ere are only two
positions of Shock Sensor and Pre Warn adjustment and this is based on position
mounting of unit. When unit is fitted in a horizontal position, the shock sensor and
pre warn are more sensitive. When fitted in a vertical position, they are less
sensitive.
3. ALARM TRIGGERS HISTORY MEMORY READ OUT VIA
SIREN AND LED
To access alarm triggers memory turn ignition on and hood opened i.e. bonnet
switch grounded. By pressing the remote control, alarm history is indicated via siren
and LED.
1 Beep, 1 Flash - Voltage Drop Alarm
2 Beep, 2 Flashes - Not Used On This Model
3 Beep, 3 Flashes - Shock Sensor Alarm
4 Beep, 4 Flashes - Power Fail Alarm
5 Beep, 5 Flashes - Ignition Alarm
6 Beep, 6 Flashes - Aux Alarm
7 Beep, 7 Flashes - Door Alarms
8 Beep, 8 Flashes - Bonnet / Boot Alarm
If two previous alarms were caused by i.e. voltage drop and shock sensor the LED
will flash and siren will beep once for voltage drop, no noise for 1 second then beep
three times for shock sensor. The memory will hold ten alarm memories. The last
memory heard is the most recent alarm sector triggered.
To exit memory mode turn ignition off and close bonnet.
