RHINO PIRW3, Инструкция по эксплуатации

Страница: 4 / 16

4
PIRW3
1. Introduction
The Rhino PIRW is a high quality infrared body movement sensor, which
is battery operated and communicates with a compatible Rhino receiver via
radio frequency (RF) transmission. This detector is easy to install, provides
excellent detection sensitivity and has a long battery life (approximately 3
years). This sensor can transmit four different codes to the receiver:
•
Alarm – sent when a valid movement is detected
•
Tamper – sent when the detector case is opened
•
Supervision – sent every 2 ½ hours to the receiver
•
Low Battery – sent when the batteries need replacing
1.1. Important notes
•
NEVER touch the pyro sensor
•
During the warm up period, (first 3 minutes after installing the
batteries) the detector will not respond to the tamper switch or
to movement in front of the detector. You must wait 3 minutes
before it will respond properly.
•
This detector has Intelligent Power Saving (IPS). This means
that in normal operation the lights will not flash every time you
move in front of the detector. When the red light flashes on for
1 second, this means that the detector has picked up and
validated body movement (or an intruder) and an alarm code is
transmitted. The detector will now go into IPS mode for
approximately 3 minutes. During this time the detector will not
trigger and no lights will turn on (see section 4 for more
information).