1
.
2
Motion Sensor Diagram
1
.
5
Attention
Since the PIR sensor can sense surrounding changes of brightness and temperature,like in places below,it may cause mis-operation or non-operation.
1. Install by qualified electricians only.
2. Make sure that the supply voltage is disconnected before installation.
3. Make sure the voltage is suitable with the lamps, And L/N/G connect properly.
4. All the lights during installation or using should not be leds’s cover vertical upside or Vertical down.
5. Don’t open the lamps without Manufacturer’s Authorization.
1.No close to plants or curtains
that sway because of wind.
2.No close to air-conditioners,
or in draft.
3.No close to marble floor or
stuff that releases intnense
radiation.
4.No close to glasses or
partition walls.
6.No facing to road on which
cars go through.
7.No being installed in places
that release strong radio waves. .
8.No being installed at the
height over 5M.
5.No close to places that can
easily vibrate.
When installation,
please put this side
downwards.
PIR Motion Sensor
Rotation
(Figure
D
)
