Rhino Drive360 Installation Guide
Link: https://kb.gpsinsight.com/rhino-drive360-installation-guide/ Last Updated: November 22nd, 2021
Copyright ©2022 GPS Insight
Page 6 of 10
A. Remove the VHB plastic exposing the adhesive.
B. Apply heat to the tape.
C. Ensuring bracket is level, press firmly to the windshield.
2. From outside the vehicle, visually inspect tape adhesion; there should be no air bubbles in the
tape. If necessary, continue to press bracket to windshield until required results are achieved.
3. Harness Installation:
A. Mount the device to the bracket and tighten large set screw.
B. Remove Security Bracket plastic exposing VHB tape.
C. Place security bracket over cable micro-USB connector; connect to the GPS device, firmly
press security bracket to the device and install bracket screw.
D. Cable tie cable along mirror wires and tighten large set screw.
