RHINO 070012, Руководство пользователя, Страница: 13 / 20

9
Rhino
®
PD-45/PD-55 Service Instructions
Following the service requirements for the PD-45 and PD-55 will
insure years of trouble free post driving.
Before any service is preformed ensure
that the unit is disconnected from air
supply and not under pressure.
Each Use:
1. Drain the water from the air compressor reservoir.
2. Ensure the air pressure setting on the FRL is correct.
3. Check oil level on the FRL and fill when needed.
Please see the instructions in the Rhino® FRL owners
manual for the FRL operation.
Routinely:
1. Drain the filter stage of the FRL regularly, especially in winter.
As needed clean the air filter element.
2. Check the bolts on your post driver to make sure they are tight.
(See Fig. 6 ) Do not over torque the bolts.
3. If you suspect the piston is not moving freely, disassemble the
driver, inspect the piston and inside wall of the cylinder for
galling. If evident, call Rhino Tool Company for assistance. If
no damage is apparent, carefully insert the piston and posi-
tion the driver body on its side. By hand, cycle the driver’s
piston back and forth while rotating slightly to make sure it
is not binding. Listen closely for scratching, and watch the
inside wall of the cylinder for abrasion from the piston. If a
new scratch appears, mark the location on the piston with a felt
tipped marker. Carefully remove the piston, inspect the side
aligned to the mark for nicks and use emery cloth to smooth
out raised edges that are evident. Carefully reinsert the piston
and repeat this process to ensure abrading is eliminated. Then
reassemble and torque bolts accordingly. (See
Fig. 6
)
4. When storing the post driver for prolonged periods, add extra
oil into the air inlet of the post driver. Slowly roll the driver
over to allow the oil to coat all inside surfaces, then stand the
driver upright, to allow any condensation to drain.
5. Immediately replace any damaged parts with new. If the driver
is not performing properly, contact Rhino or your Rhino
representative. If the problem with your Rhino unit, any part
or accessory is undetermined, contact Rhino Tool Company to
obtain a “Return Goods Authorization” number (RGA), then
send it freight prepaid to Rhino. Include your serial number if
warranty is still in place. We will conduct a free examination
to confirm what is wrong, advise you if unit can be repaired,
and any costs to be incurred.
6. If warning labels are damaged, contact Rhino to receive free
replacement labels.
!
WARNING
!
DANGER
!
CAUTION
IMPORTANT
NOTE
!
WARNING
!
DANGER
!
CAUTION
IMPORTANT
NOTE