RHINO 070012, Руководство пользователя, Страница: 11 / 20

7
It is very important to understand that your post driver is a very
powerful machine. With proper care and maintenance, your
Rhino
®
PD-45 and PD-55 will give you many years of trouble
free service. You must read and understand your post driver oper-
ating instructions before using the post driver. This post driver is
intended for use by professional installers. Never allow untrained
personnel or children to operate this tool.
Visually inspect your post driver before use. The interior of the
chuck tube should be checked for obstructions or damage to the
chuck tube. The outer surfaces of the driver should also be in -
spected for any defects. Check airlines for any abnormalities such
as bulges, wear spots or tears and replace if necessary. Inspect all
couplings are secure and safety clips are in place. Do not use if
there is any damage or until the damage is corrected and repaired.
Keep the post driver lubricated per manufacturer’s specifications.
1. Blow out air lines before coupling them to your post driver.
This precaution will help remove any dirt that may have en-
tered an open hose.
Do not turn on pressurized air through an
unsecured air line; the air line could whip
around causing serious injury.
2. Check your Filter-Regulator-Lubricator. Make sure the regula -
tor is set at no more than 90 PSI (6.2 bar). See WARNING:
AIR PRESSURE on page 1 for instructions. Make sure the
bowl has been drained and the lubricator filled with the proper
weight oil. See
LUBRICATION
on page 2.
3. Do not use a chuck or chuck
adapter that is too large for the post
being driven. See WARNING:
CHUCK SIZING , on page 2 for
instructions. If the fit is too loose
it is not safe to operate the driver,
damage may occur to the driver and
the driver may batter the end of the
post.
4. Place the driver on the post to be
driven. Position the driver ( Fig. 4 )
aligned centered to the post. If not
aligned properly, damage could
be caused to the driver or the post.
Slowly squeeze the air throttle
valve lever to start the driver.
Opening the throttle valve slowly
will prevent a violent start of the
driver. Never tape, wire, etc., the throttle valve lever open.
AIR REQUIREMENTS
PD-45: 30 CFM (0.85 m
3
/min.) @ 90 PSI (6.2 bar)
PD-55: 42 CFM (1.19 m
3
/min.) @ 90 PSI (6.2 bar)
Rhino
®
PD-45/PD-55 General Operating Instructions
!
WARNING
!
DANGER
!
CAUTION
IMPORTANT
NOTE
Fig. 4 -
Proper alignment
of driver and post .
Post
Driver
Post
RIGHT WRONG